Event Signal Setup

Note: This command is only available when the D-7000 Interface Module is selected on the Method Configuration screen.

Use this command to initiate the review or modification of Event Signal parameters.

Tool Bar Shortcut

Click on .

Event Signal Table

Time(min): Specify the time at which event signals are sent.

Port No. Columns: Select type of signal to be generated (Pulse, On, Off, or blank) for each port. You can enter signals in up to eight columns (Port 1 through Port 8).

Note: You should not enter duplicate times in two or more rows. For each port (each column), you should only enter either Pulse or On/Off event signals. You cannot make a mixed set up for a port, i.e., you cannot mix Pulse with On/Off signals. The HSM validates the Event Table Setup when you save the Method. Warning messages are displayed if invalid entries are detected.